GPS Devices
- Ublox NEO-7M GPS
- GPS Active Antenna
- Neo-7 GPS and Arduino Application
Ublox NEO-7M GPS
GPS Active antenna
Specifications:
- GNSS engine for GPS/QZSS, GLONASS
- GPS module size: 23 * 17mm
- Dual GPS Antenna Interface: SMA and IPEX
- Baud rate and other data can be saved without power
- Serial data output of raw data
- Can be accessed at 5V and 3.3V
The Datasheet can be access here:
https://www.u-blox.com/sites/default/files/products/documents/NEO-7_DataSheet_%28UBX-13003830%29.pdf
[Top][Home]
GPS Active Antenna
GPS Active antenna
- GPS Active Antenna SMA male connector
- Length: 9feet (3m)
- Center Frequency: 1575.42MHz-3MHz / 1575.42MHz+3MHz
- LNA Gain(Without cable): 25dB
- Noise Figure: less than 1.5dB
- V.S.W.R: less than 2.0
- DC current: 10mA Max
- Mounting: Magnetic base
- Housing: Black
- Working Temp: -40C~+85C
- Humidity: Humidity 95%~100%RH
- Weatherproof: 100% Weatherproof
- Voltage: 3~5V
[Top][Home]
Neo-7 GPS and Arduino Application
This project investigtes the Ublox Neo7 GPS module with an Arduino application.
There are two sketches, one is the sketch from Arduino Playground The second extracts
time and position data from the $GPGGA sentance into an array for further proceesing.
https://rydepier.wordpress.com/2015/12/22/ublox-neo-7-gps-module-with-arduino/
rydepier/UBlox-NEO-7-GPS-and-Arduino - Source Archive"
[Top][Home]
Glenn Lyons VK4PK
glenn@LyonsComputer.com.au
Ver:gnl20180608 - pre published v0.9